Installing the ADV Kit for the Crown 3.

 

How to install the Crown 3 ADV Kit.

 1.) ALL Four Orings in the Picture above are present to prevent leaks. 

The two that come installed on the ADV Kit by Inked ATTY. (Black in the Photo)

Also Two that come with the Original Crown 3 glass. (Red in the Photo)

 

 

How to install the Crown 3 ADV Kit.

  2.) All Orings will face towards the ADV Quartz Glass.

 

 

How to install the Crown 3 ADV Kit.

3.) Make sure the Orings are down inside the Crown 3 chimney setup. Once the two chimney ends are stuck through each side of the ADV Glass, Turn the Chimney Clockwise and be careful to not cross-thread the ends incorrectly.

 

 

 

How to install the Crown 3 ADV Kit.

 4.) Lock the ADV Kit and the Crown 3 devices with the locking nut. 

Turn Counter-Clockwise to Lock

 

 

 

How to install the Crown 3 ADV Kit.

 5.) Turn over and Slide in the Coil. There are two sets of Orings on the Coil. Only one set should be showing and setting flush with the device.

 

 

How to install the Crown 3 ADV Kit.

 6.) Place the 510 Cap over the Coil and thread carefully, clockwise.

 

 

How to install the Crown 3 ADV Kit.

 7.) Turn over, fill the device with ejuice, and screw on the drip tip cap.

Wait around 10 minutes to soak the coil and then Vape ALL DAY!